A 2mm thick, 3.6mtr long Z28 structural grade galvanised press braked steel section. White polyester powder coated to RAL 9010 gloss. Although others colours are available on request.

Primarily used for suspension of ceiling insulation panels in a freezer application, it can also be used for general suspension needs. The A2 section offers a thermal break at the point of contact between the section and suspension rod, preventing the tracking of cold into the roof void.

A modified section has been developed for use against fire walls to give independent support for the ceiling panels

The A2 ceiling section has been tested independently to carry a loading of 285 kilos per mtr.

A 2mm thick, 3.6mtr long Z28 structural grade galvanised press braked steel section. Comes with a white Corus Steel foodsafe coverstrip as standard. Although other colours and finishes are available on request.

The most commonly used ceiling support section, can be used in food preparation areas, clean rooms, distribution centres amongst others.

A modified section has been developed for use against fire walls to give independent support for the ceiling panels etc.

The I1 Section has been tested independently to carry a loading of 300 kilos per mtr. This section has been tested and gained approval from panel manufactures for fire certification.

A 3mm thick, 3.6mtr long Z28 structural grade galvanised press brake steel section. White polyester powder coated to RAL 9010, although other colours are available upon request.

Used for the suspension of heavy panels, such as Rockwool, or when heavy services are required.

The HD1 section has been tested independently to carry a loading of 500 kilos per mtr. This section has been tested and gained approval from panel manufactures for fire certification.

An extruded aluminium section at 5.25mtr long. White polyester powder coated to RAL9010, although other colours are available on request.

It is used for the suspension of panels, when a clean flush finish is required.

The C2 section has been tested independently to hold 300 kilos per mtr. This section is not suitable for any fire rated applications.

Maxmade limited can offer a vast range of suspension methods to deal with the majority of suspension needs.
Using strut, lindaptors and wire as required we can offer supports from angle, portal beams, channel, lattice frames, purlins, and can offer solutions to non-standard beams such as timber beams.
The most common variations are described below:

The TH51, the standard suspension system from portal frames, designed and tested to hold 810 kilos, used when the ceiling support is suspended parallel to the beams.

The TH53, a special suspension system, for use with sloped portal frames. Comes ready assembled with the swivel kit in place. Designed and tested to hold 810 kilos.

Most ceiling systems need to be sealed and clamped firmly into place, to enable this, Maxmade manufacture special coverstrips that fit between the suspension drops, holding down washers, and armaflex insulation tubing, along with a wide range of silicones, rivets and screws.

In many cases the ceiling suspension and the void in the panel must be infilled, Maxmade can offer a wide range of insulation materials to infill these voids.

Back to top